back to : SAMWAY C401 hose cutter
Cutting a hose using the SAMWAY C401 cutter
DN10 2SN hose - cutting a hose with two steel braids
Cutting a hose using the C401 cutter
DN25 4 SP hose - cutting a hose with four steel braids
The full version of the manual is supplied with the cutter
User manual for the C401 hydraulic hose cutter - content summary
The C401 cutter is a professional device for cutting hydraulic hoses, perfect for workshops and service vehicles. To ensure safe and efficient operation, it is necessary to read the following instructions and follow health and safety regulations.
1. Introduction
The manual contains detailed information on the operation of the cutter, from transport and storage to maintenance and safety. It is intended for qualified users only.
2. Transport and Storage
- The cutter is delivered on a pallet and should be checked for damage after unpacking.
- Transport to the workplace can be done with a forklift or a manual pallet truck.
- In the event of storage, the device should be protected from poor weather conditions.
3. Equipment and Scope of Delivery
The cutter is ready for use and includes:
- Cutting blade with a diameter of 250 mm,
- Two support brackets,
- User manual and declaration of conformity.
4. Safety
4.1 Protective measures
Operators should use:
- Boots, safety goggles, hearing protection, gloves, and protective clothing.
4.2 Risks associated with use
During operation, risks may arise related to rotating machine parts, splinters, as well as the risk of hearing damage in the absence of protection.
4.3 Precautions
Before starting work, you must:
- Ensure that the cutting disc rotates in the direction indicated on the housing.
- Use support brackets when cutting.
5. Intended Use
The C401 cutter is designed for cutting hoses with one or two steel braids up to 2". Cutting other materials may cause damage to the device and serious injury.
6. Cutter Operation
6.1 Identification
Each cutter has an identification plate with the model name, serial number, and year of manufacture.
6.2 Control panel
The cutter is equipped with an emergency stop switch and a start/stop switch.
6.3 Installation
- The cutter should be mounted on a stable surface and secured with anchors of at least 8 mm.
- Ensure a minimum space of 1 m around the device and good lighting of the workplace.
7. Startup and Cutting
7.1 Startup
Before starting work, check that the disc is correctly mounted and the emergency stop switch is in the 'off' position.
7.2 Cutting tips
To extend the life of the cutting disc, the first 20 cuts should be made slowly, avoiding overheating and overloading the motor. Minimum section lengths for cutting vary depending on the hose diameter:
- 250 mm for diameters 3/16”–1/2”,
- 350 mm for 5/8”–1”,
- 500 mm for 1 1/4”–2”.
8. Maintenance
- After each working day, turn off the device, clean it of waste, and check the condition of the disc and electrical connections.
9. Technical Data
- Max. hose diameter: 60 mm,
- Motor power: 2.2 kW (230V) or 3.0 kW (400V),
- Speed: 2880 rpm,
- Disc diameter: 250 mm,
- Dimensions: 780 mm x 550 mm x 1100 mm,
- Weight: 105 kg.
10. Warranty
The cutter is covered by a one-year warranty, which applies if the recommendations in the manual are followed.