back to : SAMWAY C401 hose cutting machine
Cutting a hose using the SAMWAY C401 cutting machine
Hose DN10 2SN - cutting a hose with two steel braids
Cutting a hose using the C401 cutting machine
Hose DN25 4 SP - cutting a hose with four steel braids
The full version of the manual is supplied with the cutting machine
User manual for the C401 hydraulic hose cutting machine - table of contents summary
The C401 cutting machine is a professional device for cutting hydraulic hoses, perfect for workshops and service vehicles. To ensure safe and efficient operation, it is necessary to read the following instructions and comply with health and safety regulations.
1. Introduction
The manual contains detailed information on operating the cutting machine, from transport and storage to maintenance and safety. It is intended for qualified users only.
2. Transport and Storage
- The cutting machine is delivered on a pallet, and after unpacking, it should be checked for any damage.
- Transport to the workplace can be done using a forklift or a pallet jack.
- In case of storage, the device should be protected against adverse weather conditions.
3. Equipment and Scope of Delivery
The cutting machine is ready for use and includes:
- A cutting blade with a diameter of 250 mm,
- Two support brackets,
- Operating manual and declaration of conformity.
4. Safety
4.1 Protective measures
Operators should use:
- Safety shoes, protective glasses, ear protection, gloves, and protective clothing.
4.2 Risks associated with use
When operating, risks related to rotating machine parts, splinters, as well as the risk of hearing damage without protection may occur.
4.3 Precautions
Before starting work, you must:
- Ensure that the cutting blade rotates in the direction indicated on the housing.
- Use support brackets when cutting.
5. Intended use
The C401 cutting machine is designed for cutting hoses with one or two steel braids up to 2". Cutting other materials may cause device damage and serious injury.
6. Machine Operation
6.1 Identification
Each cutting machine has an identification plate with the model name, serial number, and year of manufacture.
6.2 Control panel
The cutting machine is equipped with an emergency stop switch and a start/stop switch.
6.3 Installation
- The cutting machine should be fixed on a stable surface and secured with anchors of at least 8 mm.
- Ensure a minimum space of 1 m around the device and good lighting of the workplace.
7. Startup and Cutting
7.1 Startup
Before starting work, check if the blade is correctly fixed and the emergency stop switch is in the 'off' position.
7.2 Cutting tips
To extend the life of the cutting blade, the first 20 cuts should be performed slowly, avoiding overheating and motor overload. Minimum cutting section lengths vary depending on the hose diameter:
- 250 mm for diameters 3/16”–1/2”,
- 350 mm for 5/8”–1”,
- 500 mm for 1 1/4”–2”.
8. Maintenance
- After each working day, turn off the device, clean it of debris, and check the condition of the blade and electrical connections.
9. Technical Data
- Max. hose diameter: 60 mm,
- Motor power: 2.2 kW (230V) or 3.0 kW (400V),
- Speed: 2880 rpm,
- Blade diameter: 250 mm,
- Dimensions: 780 mm x 550 mm x 1100 mm,
- Weight: 105 kg.
10. Warranty
The cutting machine is covered by a one-year warranty, which is valid provided that the recommendations in the manual are followed.