Back to section : troubleshooting
How to check if the solenoid valve is working properly ?
Despite pressing the button the crimping machine does not react ?
Follow the steps below to check.
1. If the crimping machine was moved to another location ( to another power outlet ) check the motor rotation direction ( if necessary change phases L1 to L3 in the socket )
Checking the hydraulic solenoid valve
2. If the motor rotation is correct, check if the solenoid valve located under the head is working properly
- check if the solenoid valve coils are working ( press the crimping button and check if the coil lights up red, check opening and check the second coil )

- press the point marked in the photo to check mechanically if the solenoid valve will work ( this is a way to control crimping and opening without an electrical signal from the coil ) all you need is an Allen key and to press the marked point for the solenoid valve to start working ( crimping or opening ) depending on whether you pressed the left or right valve.

These are things you can do yourself without fear of damaging the machine
In case the main jaws do not work ( opening or closing ). By pressing the opening or closing button, we check if the indicator lights on the solenoid valve ( two coils on the sides under the head ) light up; both should light up when pressed. If the LED on the coil does not light up, unscrew the front panel of the machine (Allen screws) and plug in the cable connector, which has most likely slipped out of the control board. ( the connectors are labeled and sized so as not to make a mistake ). In other cases, the solenoid valve spool is most likely stuck. In such a case, unscrew both connectors leading to the solenoid valve ( under the head ) using a Phillips screwdriver. Next, use an Allen key to unscrew the four Allen screws with which the solenoid valve is tightened to the distributor block.
Checking the solenoid valve
I suggest placing a small cloth under the solenoid valve as some oil will leak out after unscrewing. After removing the solenoid valve, visually check if there is any mechanical contamination in the four channels causing it to stick. There are four small O-rings in the channels, so be careful not to lose them. Then unscrew the two coils on the sides and check if the plungers on both sides work. Sometimes just tapping is enough to unblock the plunger. In the case of a stuck solenoid valve, the jaws will not close or the jaws will close to the point of resistance until an overload is heard; in such cases, the machine must be disconnected immediately. It may even happen that under pressure, the motor rotation direction changes, but these are extreme situations.
Check also: