Back to section : troubleshooting
How to check if the solenoid valve is working correctly ?
Despite pressing the button the crimping machine is not responding ?
Follow the steps below to check.
1. If the crimping machine has been moved to a different location ( to a different power outlet ) check the motor rotation direction ( if necessary, change phases L1 to L3 in the socket )
Checking the hydraulic solenoid valve
2. If the motor rotation is correct, check if the solenoid valve located under the head is working properly
- check if the solenoid valve coils are working ( press the crimping button and check if the coil lights up red, check opening and check the second coil )

- press the point marked in the photo to mechanically check if the solenoid valve will work ( this is a way to control crimping and opening without an electrical signal from the coil ) all you need is an Allen key and to press the marked point for the solenoid valve to start working ( crimping or opening ) depending on whether you pressed the left or right valve.

These are things you can do yourself without fear of damaging the machine
In the event that the main jaws do not work ( opening or closing ). By pressing the opening or closing button, we check if the indicator lights on the solenoid valve ( under the head, two coils on the sides ) light up; both should light up when pressed. If the LED on the coil does not light up, we unscrew the front panel of the machine ( Allen screws ) and plug in the cable connector, which has most likely slipped out of the control board. ( the connectors are labeled and sized to match so as not to make a mistake ). In other cases, the solenoid valve spool has most likely jammed. In such a case, we unscrew using a Phillips screwdriver both connectors leading to the solenoid valve ( under the head ). Then, using an Allen key, we unscrew the four Allen screws with which the solenoid valve is fastened to the manifold block.
Checking the solenoid valve
I suggest placing a small cloth under the solenoid valve; some oil will leak after unscrewing. After removing the solenoid valve, we visually check if there is any mechanical contamination in the four channels causing jamming. There are four small O-rings in the channels, so we are careful not to lose them. Then, we unscrew the two coils on the sides and check if the plungers on both sides are working. Sometimes it is enough to tap it for the plunger to unlock. In case of a jammed solenoid valve, the jaws do not close, or even the jaws close until they stop and an overload can be heard; in such cases, the machine should be disconnected immediately. It may even happen that the motor rotation direction changes under pressure, but these are extreme situations.
Check also: