Skip to main content


Fluid power hydraulics - parts, accesories

Experienced Polish manufacturer & direct distributor of hydraulic components   
Retail & Wholesale – One-Stop Industrial Supplier | 100% European-owned    
   

six-time winner
Business Gazelles 2024

NATO supplier
Code 99Q4H
HYDRON NCAGE code

proven reliability
HYDRON DUNS number

authorized
service
Authorized ENERPAC Service Center in Poland

official
distributorUSA
Authorized ENERPAC distributor in Poland

official distributorEU SEMPERIT distributor

quality assurance
ISO 9001, TUV
HYDRON ISO certificates

📦 15,000+ items in our stock & ready to ship
⚡ Fast shipping 🛡️ Quality guarantee 🛠️ Technical support
Products in the cart: 0. See details
Your cart is empty

Damage to the front plate in an electric crimping machine

FAQ - questions and answers

Damage to the front plate in electric crimping machine

What improper operation of the crimping press leads to.  

Below, find out why the micrometer must not be set below the zero dimension ! 

Zero dimension on the micrometer means that the dies close completely - the cylinder pushes the head until the end, then it touches the sensor in the micrometer, which sends a signal to the solenoid valve to cut off ( so that the cylinder does not move forward ). With the micrometer, we can only add millimeters ( we can add on the micrometer, we cannot set a negative value on the micrometer because this may cause damage to the front plate of the crimper ) During correct operation, the cylinder is pushed to the zero point ( complete closure of the crimping dies ) and the micrometer sends a signal so that the solenoid valve is cut off. 

When setting the micrometer to a negative value, the cylinder will be pushed further ( the head will not touch the micrometer inside and will not receive a signal to turn off the solenoid valve ) Cylinder will be pushed further and only the front plate of the head stands in its way - this plate will crack if it receives pressure for too long ! It's like driving a car to a garage - if we pull up to the garage and don't stop but keep pressing the gas pedal, we will certainly destroy the gate and drive inside. 

When will such a case occur ? 

This phenomenon cannot occur during correct operation ( according to the instructions ) The case presented here is extremely rare. 

In the case below, the customer did not want to change the dies to crimp a hose ( recall that dies are selected for a specific hose size according to the crimping table ) and came up with the not-so-clever idea to set the dies to a negative value - so that the crimper would crimp to a smaller dimension than the dies that were installed ) The result of such actions was a crack in the front plate. The phenomenon has been well illustrated here. 

view of the damaged front plate 

damage to the front plate of the crimper head

example of crimper damage

 

 

Realize what force must act to destroy 7.5cm of metal ! Crimping force of 300 tons ! 

with such force the cylinder crimps ( pushes the head ) 

 front plate of the crimper head