Damage to the front plate in an electric crimping machine
What improper operation of the crimping press leads to.
Below is why you cannot set the micrometer below the zero dimension !
The zero dimension on the micrometer means that the dies close completely - the cylinder pushes the head until the end, after which it touches the sensor in the micrometer, and the sensor sends a signal to the solenoid valve to shut it off ( so that the cylinder does not move forward ). With the micrometer, we can only add millimeters ( we can add on the micrometer, we cannot set a negative value on the micrometer because this may cause damage to the crimper's front plate ) During proper operation, the cylinder is pushed to the zero point ( complete closure of the crimping dies ) and the micrometer sends a signal to shut off the solenoid valve.
When the micrometer is set to a negative value, the cylinder will be pushed further ( the head will not touch the micrometer inside and will not receive a signal to turn off the solenoid valve ) Cylinder will be pushed further and only the front plate of the head stands in its way - this plate will crack if it receives pressure for too long ! It's like driving a car to a garage - if we approach the garage and don't stop but keep pressing the gas pedal, we will certainly destroy the gate and drive inside.
When will this occur ?
- if we set the micrometer to a negative value
- when we do not follow the instructions ( we select incorrect dies for the crimped element )
There is no possibility of this phenomenon occurring during correct operation ( according to the instructions ) The case presented here is extremely rare.
In the case below, the customer did not want to change the dies to crimp a hose ( recall that dies are selected for a specific hose size according to the crimping table ) and came up with a not-so-smart idea to set the dies to a negative value - so that the crimper would crimp to a smaller dimension than the dies that were installed ) The result of this action was a crack in the front plate. The phenomenon has been well illustrated here.
view of the damaged front plate


Realize what force must be applied to destroy 7.5cm of metal ! A crimping force of 300 tons !
with such force the cylinder crimps ( pushes the head )
