Principles of skiving 4SP and 4SH hoses (four-wire spiral hoses)

We skive four-wire spiral hoses externally and internally. During skiving, remember to hold the hose firmly with both hands while cutting. After measuring the hose, select the appropriate mandrel or cutting knife. Note that after placing the hose on a mandrel matching its diameter, we cut the top layer using the counter-clockwise (left) motor rotation. Clockwise (right) motor rotation is used when skiving the hose from the inside to seat the coupling. When starting to skive the hose externally, ensure that after the ferrule is placed and crimped, no skiving is visible at the back of the ferrule. If the hose has been skived too much, apply the principle of pressing the ferrule tighter against the hose.
External skiving of 4SP hose
Tip: Select the appropriate mandrel that fits the internal diameter of the hose. Then, place the mandrel in the skiver holder, tightening the screw with the holder knob.
Internal skiving of 4SP hose
Tip: In the case of internal hose skiving, install a mandrel with a knife in the skiver, adjusting the knife to the hose.