Skip to main content


Fluid power hydraulics - parts, accesories

Experienced Polish manufacturer & direct distributor of hydraulic components   
Retail & Wholesale – One-Stop Industrial Supplier | 100% European-owned    
   

six-time winner
Business Gazelles 2024

NATO supplier
Code 99Q4H
HYDRON NCAGE code

proven reliability
HYDRON DUNS number

authorized
service
Authorized ENERPAC Service Center in Poland

official
distributorUSA
Authorized ENERPAC distributor in Poland

official distributorEU SEMPERIT distributor

quality assurance
ISO 9001, TUV
HYDRON ISO certificates

📦 15,000+ items in our stock & ready to ship
⚡ Fast shipping 🛡️ Quality guarantee 🛠️ Technical support
Products in the cart: 0. See details
Your cart is empty

P20HP crimping machine user manual

back to : SAMWAY P20HP manual crimping machine

Manual for the SAMWAY P20HP manual hose crimping machine

this is an older version of the crimping machine ( without the quick die change system ) 

Operating instructions for the P20HP manual crimping machine

Checking the crimping diameter on the chart 

On the presented crimping machine model, we crimped DN10 3/8 inch 2SN hose (double-braid hose). After determining the internal diameter of the hose and assessing the number of steel braids inside it, we proceeded to find in the approximate crimping chart the value to which the hose should be compressed. According to the chart, the hose is to be crimped to a value of 20.6 mm.

Selection of appropriate crimping dies

Then, the closest dies to the value of 20.6 mm were selected, applying the rule that they must be dies smaller than the value in the chart. In this case, these are size 19 dies. Next, the numbered dies from 1 to 8, size 19, were placed inside the master dies. Then, the value of 1.60 was set on the micrometer by turning the micrometer knob to the right. ( 19+ 1.60 =20.6 mm). Next, the oil filler cap was loosened and the butterfly valve on the pump was tightened.

Hose crimping 

After placing the crimping ferrule along with the fitting on the hose we proceeded to crimping. Crimp until the indicator light on the micrometer turns on. After the first crimp, we proceed to compress again in order to eliminate the mark on the ferrule that was created after the first crimp. After crimping twice, we are sure that the ferrule on the hose has been properly pressed. Then we reset the micrometer using the knob (turn it to the left) and loosen the pump's butterfly valve, which will cause the clamped dies to open. We advise doing this gently so that the accumulated pressure does not cause oil to escape from under the filler cap. In the final stage, using the pin supplied with the crimping machine, we extract each of the dies from inside the head. Also check : hydraulic hose crimping manual ( extended )