Skip to main content


Fluid power hydraulics - parts, accesories

Experienced Polish manufacturer & direct distributor of hydraulic components   
Retail & Wholesale – One-Stop Industrial Supplier | 100% European-owned    
   

six-time winner
Business Gazelles 2024

NATO supplier
Code 99Q4H
HYDRON NCAGE code

proven reliability
HYDRON DUNS number

authorized
service
Authorized ENERPAC Service Center in Poland

official
distributorUSA
Authorized ENERPAC distributor in Poland

official distributorEU SEMPERIT distributor

quality assurance
ISO 9001, TUV
HYDRON ISO certificates

📦 15,000+ items in our stock & ready to ship
⚡ Fast shipping 🛡️ Quality guarantee 🛠️ Technical support
Products in the cart: 0. See details
Your cart is empty

User manual for the P32X battery-powered crimping machine

back to : SAMWAY P32X battery-powered crimping machine

User manual for the SAMWAY P32X battery-powered crimping machine 

Remember : By purchasing this machine from us, you receive free transport and training 

Battery-powered crimping machine

The P32X crimping machine is a mobile unit powered by a 12V battery. It is recommended that the battery be between 100 and 120 Ah. In practice, after a day of crimping hoses, the battery should be connected to a charger so that it can continue working the next day. 

Checking the crimping diameter 

Tip: Crimping a DN10 2SN hose with the P32Q crimper Tip: During the first crimp, you must know what kind of hose it is. Hoses have markings for their parameters. If you cannot read the values on the hose, first measure the inner diameter of the hose using a caliper. Then visually determine how many steel layers (braids) it has inside. Next, select the appropriate ferrule and hose fitting. Then check the approximate crimping table to see what dimension the hose should be crimped to. Example: DN 10 mm ( 3/8 inch) 2SN hose - two-wire braid hose. Knowing the hose parameters, we look for the value in the approximate crimping table that the hose is to be crimped to. For a DN 10 2SN hose, we read the value 20.6 mm in the table.

Selection and installation of crimping dies 

Next, we select the dies closest to the 20.6 mm parameter, applying the rule that the die size must be smaller than the value of 20.6 mm. In this case, these are size 19 mm dies. Then, applying a simple mathematical operation, i.e., 20.6 mm - 19 mm = 1.6 mm. The difference after subtracting these values gives us the parameter to be set on the micrometer, which in this case is 1.6 mm. After fitting the number 19 dies, we proceed to set the value of 1.6 mm on the micrometer. Use the micrometer dial to set the desired value. The micrometer should be zeroed before setting. Zeroing consists of setting the dial to the position where the number 0 aligns with the number 0. By turning the micrometer dial to the right, we set 1.6 mm and proceed to crimp the hose. The upper digit on the micrometer will indicate 1, while the lower one on the dial will show 60. Remember to crimp the ferrule on the hose twice. During the first crimp, a ridge forms on the ferrule, which we must eliminate by crimping it again. This action is performed by rotating the ferrule on the hose so that the dies press down on the ridge formed in that spot. 

See also : hydraulic hose crimping manual ( extended )