back to : SAMWAY P20Q crimping machine
User manual for the SAMWAY P20Q crimping machine

Hose crimping
First crimp step by step
After connecting the crimper to the power source (5 pin 16A plug - 3 phase power supply), start the machine using the red switch. Important: the rotation of the motor rotor must be directed to the right for the proper operation of the oil suction pump. In case of left-hand rotation, the phases inside the plug must be swapped. Underneath the machine, there is a table where the dies are mounted. In the P20Q model, we have the following crimping die sizes : 14,16,19,22,26,30,34,39,45. The provided die dimensions specify their internal diameter after crimping. The presented instructional video uses a DN6 1SN hose (internal hose diameter 6 mm - single-braid hose.
Die selection
In order to select the correct dies, we check in the APPROXIMATE CRIMPING CHART at what diameter we are to crimp the hose. In the vertical column, we have the internal hose diameters starting from 5 mm 3/16 inch up to 50 mm 2 inches. The horizontal part of the chart presents the types of hoses starting from thin-walled hoses ending with 4-wire braid hoses. When selecting the appropriate dies for the hose to be crimped, we follow the principle: LOOK FOR THE DIE SIZE CLOSEST TO THE CRIMPING DIAMETER ACC. TO THE APPROXIMATE CRIMPING CHART. The dies used must always be smaller than the parameter specified in the approximate crimping chart. In the case of a DN6 1SN hose, the crimp acc. to the chart is 15, 7mm. Therefore, we use die number 14 because the next ones after them are size 16 and are too large. Next, we set the desired value using the micrometer. Remember, when mounting any dies, the micrometer must be zeroed. By turning the micrometer knob to the right, we set the value to 1,70 mm. ( die size 14 + 1,7 = 15,7 mm). Subsequently, we insert the hose with the ferrule in which the fitting is located and proceed to the first crimp. When positioning the hose for crimping, remember that the ferrule should be slightly recessed in the dies with which you are crimping the ferrule. By pressing the die closing button, we crimp the ferrule. After the first crimp, a ridge will appear, which should be eliminated by crimping again. At the very end, zero the micrometer using the knob. Then close the dies to the very end. Insert the quick-change tool. Open the dies using the button and remove them from the interior.
SAMWAY P20Q crimping machine
