back to : SAMWAY P20Q hose crimper
User manual for the SAMWAY P20Q hose crimper

Hose crimping
The first crimp step by step
After connecting the crimper to the power source (5-pin 16A plug - 3-phase power supply), start the machine using the red switch. Important: the motor rotor rotation must be directed to the right for the correct operation of the oil suction pump. In the case of left-hand rotation, the phases inside the plug must be swapped. Underneath the machine, there is a table in which the dies are mounted. In the P20Q model, we have the following crimping die sizes: 14,16,19,22,26,30,34,39,45. The specified die dimensions determine their internal diameter sizes after crimping. In the presented instructional video, a DN6 1SN hose was used (hose internal diameter 6 mm - single-braid hose).
Selecting die sets
In order to correctly select the die sets, we check in the CRIMPING REFERENCE CHART what diameter we should crimp the hose to. In the vertical column, we have the internal hose diameters starting from 5 mm 3/16 inch to 50 mm 2 inches. The horizontal part of the table presents the types of hoses starting from thin-walled hoses and ending with 4-braid hoses. When selecting the appropriate dies for the hose being crimped, we follow the principle: LOOK FOR DIE SETS WITH A SIZE CLOSEST TO THE CRIMPING DIAMETER ACCORDING TO THE CRIMPING REFERENCE CHART. The dies used must always be smaller than the parameter given in the crimping reference chart. In the case of a DN6 1SN hose, the crimp according to the table is 15.7 mm. Therefore, we use die set number 14 because the next size is 16 and is too large. Next, set the desired value using the micrometer. Remember, when mounting any dies, the micrometer must be zeroed. By turning the micrometer knob to the right, set the value to 1.70 mm. (die size 14 + 1.7 = 15.7 mm). Then place the hose with the ferrule containing the fitting and proceed to the first crimp. When positioning the hose for crimping, remember that the ferrule should be slightly recessed in the dies used to crimp it. By pressing the die closing button, we crimp the ferrule. After the first crimp, a ridge will appear, which should be eliminated by re-crimping. At the very end, zero the micrometer using the knob. Then close the dies to the very end. Insert the quick-release tool. Open the dies using the button and remove them from the inside.
SAMWAY P20Q hose crimper
