go back to : FAQ - crimping machine troubleshooting
Crimping an excessively hard element on a crimping machine
A 1 in 1000 case
Crimping an excessively hard element on a crimping machine such as a steel wire rope may in certain circumstances cause problems. In the case of a standard rubber hose the crimped ferrule always has room to narrow (it contracts and compresses the hose). In the case of crimping a steel wire rope the load will be significantly higher - the hydraulic pump will pump continuously to push the crimper piston > so that the dies close to the set diameter. In the case of steel wire ropes, an attempt to crimp the rope too tightly may end up tearing the cutting ring from the tube connecting the hydraulic pump to the head supply valve. Under the influence of resistance,the pressure in the crimper's hydraulic system will increase - this will happen at the moment when we have crimped the rope so tightly that it has no further room to narrow.
tearing of the cutting ring


Check also :