back to : hose crimping training or crimping machine service
FAQ - crimping machine troubleshooting
Below we present all the most common causes of problems encountered by customers. 99% of problems are caused by incorrect use of the machine. In this section, we will publish the most popular questions asked by users.
- What does the crimping machine warranty cover
- Read information about the natural gradual wear and tear of machines and devices
Electric crimping machines
- minor leak from under the crimping head
- mechanical damage
- the crimper crimps to the wrong diameter
- problem with the micrometer in the electric crimping machine
- crimper micrometer calibration
- incorrect die selection and its consequences
- crimping an element that is too hard ( rope or metal rod )
- front plate damage in manual or pneumatic crimping machines
- front plate damage in electric crimping machines
- crimping machine does not respond > how to check the solenoid valve and coils
- poor lubrication of the head and master dies
Manual, pneumatic crimping machines, cutting machines
- cutting blade damage / mechanical damage to the cutting blade
- damage to the front plate in the crimping machine
- problem with the micrometer in the manual crimping machine
- manual crimper pump "skips"
- damage and leak from the pneumatic pump tank
- oil leak from the manual crimper head
Read also :
- how to pack (secure) a manual crimping machine for service
- how to file a warranty claim for a crimping machine
- a classic example of an unjustified claim
IN CASE THE MACHINE DOES NOT WORK ( electric )
These are things you can do yourself without fear of damaging the machine
- check the direction of rotation of the crimper ( whether the motor turns clockwise ) if necessary change the cable in the L1 to L3 plug
- first of all, check if there is power in the socket; it happens that after connecting the crimper, the fuse trips in the distribution board. It must be at least 20 - amp so that the work of the crimping machine is stable.
- in case of no power, check the cable connecting the machine to the power source. The pins on the plug or inside the crimper may be loose.
- in case of an electrical surge, there is also a Siemens Sirius protection inside the crimper (just unscrew the housing with 4 Allen screws – the panel where the main switch is located) and switch it from the OFF to the ON position.
- during transport, it may happen that one of the pins inside the crimper has come loose ( we had such a case ) Unscrew two plates using Allen keys ( one with the die closing and opening control – the other with the main switch). Then visually assess whether all cables with pins are seated in the control board. They are of different widths so as not to make a mistake when connecting them. Press those that are loose into the board.