back to : hose crimping training or crimping machine service
FAQ - crimping machine troubleshooting
Below we present all the most common causes of problems encountered by customers. 99% of problems are caused by improper use of the machine. In this section, we will publish the most popular questions asked by users.
- What does the crimping machine warranty cover
- Read information about the natural gradual wear and tear of machines and equipment
Electric crimping machines
- minor leak from under the crimping head
- mechanical damage
- the crimper crimps to the wrong diameter
- problem with the micrometer in the electric crimping machine
- micrometer calibration in the crimping machine
- incorrect die selection and its consequences
- crimping an element that is too hard ( rope or metal rod )
- front plate damage in a manual, pneumatic crimping machine
- front plate damage in an electric crimping machine
- the crimping machine does not respond > how to check the solenoid valve and coils
- poor lubrication of the head and main dies
Manual, pneumatic crimping machines, cutting machines
- cutting blade damage / mechanical damage to the cutting blade
- damage to the front plate in the crimping machine
- problem with the micrometer in the manual crimping machine
- pump in the manual crimping machine "skips"
- damage and leak from the pneumatic pump tank
- oil leak from the head of the manual crimping machine
Read also :
- how to pack (secure) a manual crimping machine for service
- how to file a complaint for a crimping machine
- a textbook example of an unjustified complaint
IN CASE THE MACHINE DOES NOT WORK ( electric )
These are things you can do yourself without fear of damaging the machine
- check the direction of rotation of the crimping machine ( whether the motor turns clockwise ) if necessary change the cable in the plug from L1 to L3
- first of all, check if there is power in the power socket, it happens that after connecting the crimping machine it trips the circuit breaker on the switchboard. It must be at least a 20 - amp for the work of the crimping machine to be stable.
- in case of no power, check the cable connecting the machine to the power source. The plugs might be loose on the connector or inside the crimping machine.
- in case of an electrical surge, there is also a Siemens Sirius protector inside the crimper (just unscrew the casing with 4 Allen screws – the panel where the main switch is located) and switch it from the OFF to the ON position.
- during transport it may happen that one of the pins inside the crimping machine has come loose ( we have had such a case ) Unscrew two plates using Allen keys ( one with the die closing and opening control – the other with the main switch). Then visually assess whether all cables with pins are seated in the control board. They are of different widths so as not to make a mistake when connecting them. Press those that are loose into the board.