back to : hose crimping training or crimping machine service
FAQ - troubleshooting the crimping machine
Below we present all the most common causes of problems encountered by customers. 99% of problems are caused by incorrect use of the machine. In this section, we will publish the most popular questions asked by users.
- What the crimping machine warranty covers
- Read information about the natural gradual wear and tear of machines and devices
Electric crimping machines
- minor leak from under the crimping head
- mechanical damage
- crimping machine crimps to the wrong diameter
- problem with the micrometer in an electric crimping machine
- micrometer calibration in a crimping machine
- incorrect die selection and its consequences
- crimping an element that is too hard ( rope or metal rod )
- damage to the front plate in a manual, pneumatic crimping machine
- damage to the front plate in an electric crimping machine
- crimping machine does not respond > how to check the solenoid valve and coils
- poor lubrication of the head and main dies
Manual crimping machines, pneumatic machines, cutting machines
- cutting disc damage / mechanical damage to the cutting disc
- damage to the front plate in the crimping machine
- problem with the micrometer in a manual crimping machine
- pump in the manual crimping machine "skips"
- damage and leak from the pneumatic pump tank
- oil leak from the head of a manual crimping machine
Read also :
- how to pack (secure) a manual crimping machine for service
- how to file a claim for a crimping machine
- a model example of an unjustified claim
IN CASE THE MACHINE DOES NOT WORK ( electric )
These are things you can do yourself without fear of damaging the machine
- check the rotation direction of the crimping machine ( whether the motor turns clockwise ) if necessary, change the cable in the plug L1 to L3
- first of all, check if there is power in the power socket, it happens that after connecting the crimping machine, the protection in the switchboard trips. It must be a minimum of 20 - amp for the work of the crimping machine to be stable.
- in case of no power, check the cable connecting the machine to the power source. The pins on the plug or inside the crimping machine may be loose.
- in case of an electrical surge, there is also a Siemens Sirius protection inside the crimper (just unscrew the housing with 4 Allen screws – the panel where the main switch is located) and switch it from the OFF position to the ON position.
- during transport, it may happen that one of the pins inside the crimping machine has come unplugged ( we had such a case ) Unscrew two plates using Allen keys ( one with the die closing and opening control – the other with the main switch). Then optically assess whether all cables with pins are seated in the control board. They are of different widths so as not to make a mistake when connecting them. Press those that are loose against the board.