return to : hose crimping training or crimping machine service
FAQ - troubleshooting the crimping machine
Below we present all the most common causes of problems encountered by customers. 99% of problems are caused by improper use of the machine. In this section, we will publish the most popular questions asked by users.
- What is covered by the warranty for crimping machines
- Read information about the natural gradual wear and tear of machines and equipment
Electric crimping machines
- minor leak from under the crimper head
- mechanical damage
- crimper is crimping to the wrong diameter
- problem with the micrometer in the electric crimping machine
- micrometer calibration in the crimping machine
- incorrect selection of dies and its consequences
- crimping an element that is too hard (rope or metal rod)
- damage to the front plate in a manual, pneumatic crimping machine
- damage to the front plate in an electric crimping machine
- crimper does not respond > how to check the solenoid valve and coils
- poor lubrication of the head and master dies
Manual, pneumatic crimping machines, cutting machines
- cutting disc damage / mechanical damage to the cutting disc
- damage to the front plate in the crimping machine
- problem with the micrometer in the manual crimping machine
- the pump in the manual crimping machine "skips"
- damage and leak from the pneumatic pump tank
- oil leak from the head of the manual crimping machine
Read also :
- how to pack (secure) a manual crimping machine for service
- how to file a claim for a crimping machine
- a textbook example of an unjustified claim
IN CASE THE MACHINE IS NOT WORKING ( electric )
These are things you can do yourself without fear of damaging the machine
- check the direction of rotation of the crimper (whether the motor turns clockwise) if necessary change the cable in the plug L1 to L3
- first of all check if there is power in the power socket, it happens that after connecting the crimper it trips the circuit breaker on the distribution board. It must be at least a 20-amp breaker for the work of the crimping machine to be stable.
- in case of no power, check the cable connecting the machine to the power source. There may be loose pins on the plug or inside the crimping machine.
- in case of an electrical surge, there is also a Siemens Sirius protector inside the crimper (just unscrew the casing with 4 Allen screws – the panel where the main switch is located) and switch it from OFF to ON.
- during transport, it may happen that one of the pins inside the crimping machine has come unplugged (we have had such a case). Unscrew two plates using Allen keys (one with the control for opening and closing the dies – the other with the main switch). Then visually assess whether all the wires with pins are seated in the control board. They are of different widths so as not to make a mistake when connecting them. Press those that are loose into the board.