back to : crimped hydraulic hoses
How to order a hydraulic hose ?
To correctly order a complete hydraulic hose, it is essential to provide a few basic pieces of information that will allow for the unambiguous identification of the hose.
We need the following information :
- hose type,
- hose length,
- hose end, i.e., information about the thread
- and information about any potential covers or a special fitting orientation angle.

1. Type of hydraulic hose fitting
The most important thing is to specify whether the fitting is straight or angled, then the type of seal, e.g., 60-degree cone or flat. More information about the seals and hydraulic fitting types used can be found in the section "fitting seal types". Next, it is necessary to provide the thread size. Read more about > how to measure the thread. Once the thread has been measured, you need to check the table to see what thread it is "thread selection table". Often customers ask if providing the wrench size is enough .... no, it's not enough ;) Providing the wrench size is not any kind of information. Examples of fitting identification : Straight for size 22 wrench - wrong ! Straight fitting with BSP 3/8" internal thread - correct !
2. Hose type
You can read the marking from the old hose. When ordering a hose, we must provide its internal diameter expressed in millimeters or inches, e.g., DN10, which is 3/8". The types of available hoses and their diameters, as well as working pressure, can be found in the "hose selection table". You should specify what the hose will be used for, e.g., oil, crude oil, acids! This is very important ! There are many varieties of hoses used for special tasks, e.g., hoses for hot oil ( standard hoses work up to 80 degrees ). Read more about how to read symbols / information from a hydraulic hose. The most standard hoses are : hydraulic hose with 2 steel braids
3. Hose length
When specifying the hose length, we have the option to provide the total length, i.e., measured from fitting to fitting, or we can provide the length of the hose itself ( without fittings ) More on how to determine the length of a hydraulic hose
4. Fitting orientation angle
Check how to correctly determine the fitting orientation angle
4. Hose cover
The hose can be in a textile sleeve ( fabric ), plastic sleeve ( spiral ) or a metal cover ( protective spring )
Order standard ready-made hoses
On the Crimped hoses page, standard crimped hydraulic hoses are available, which can be ordered in various lengths, various diameters, and various working pressures. Hoses are ready for immediate use. Each hose meets the highest quality standards and is carefully tested to guarantee reliability and resistance to high pressures. We process orders the same day. If you have a problem identifying the threads, you can send us the cut-off fittings - we will make a hose with exactly the same fittings.