back to : crimped hydraulic hoses
How to order a hydraulic hose ?
To correctly order a complete hydraulic hose, it is essential to provide a few basic pieces of information that will allow for unambiguous identification of the hose.
We need the following information :
- hose type,
- hose length,
- hose end, i.e., thread information
- and information about any guards or a specific fitting orientation angle.

1. Type of hydraulic hose fitting
The most important thing is to specify whether the fitting is straight or elbow, then the sealing type, e.g., 60-degree cone or flat. More information about the seals used and hydraulic fitting types can be found in the section "fitting seal types". Then it is necessary to provide the thread size. Read more about > how to measure a thread. Once the thread is measured, you need to check in the table what kind of thread it is "thread selection table". Customers often ask if providing the wrench size is enough .... no, it is not ;) Providing the wrench size does not constitute any information. Examples of fitting identification : Straight for 22 wrench - wrong ! Straight fitting with 3/8" BSP female thread - correct !
2. Hose type
You can read the markings from the old hose. When ordering a hose, we must provide its internal diameter expressed in millimeters or inches, e.g., DN10 which is 3/8". The types of available hoses and their diameters, as well as working pressure, can be found in the "hose selection table". You should specify what the hose will be used for, e.g., oil, diesel, acids! this is very important! There are many variations of hoses used for special tasks, e.g., hot oil hoses ( standard hoses work up to 80 degrees ). Read more about how to read symbols / information from a hydraulic hose. The most standard hoses are : hydraulic hose with 2 steel braids
3. Hose length
When specifying the hose length, we can provide the total length, i.e., measured from fitting to fitting, or we can provide the length of the hose itself (without fittings). More on how to determine the length of a hydraulic hose
4. Fitting orientation angle
Check how to correctly determine the fitting orientation angle
4. Hose guard
The hose can be in a textile sleeve ( rag ), plastic sleeve ( spiral ) lub osłonie metalowej ( protective spring )
Order standard ready-made hoses
On the page Crimped hoses standard, crimped hydraulic hoses are available, which can be ordered in various lengths, various diameters, and various working pressures. The hoses are ready for immediate use. Each hose meets the highest quality standards and is carefully tested to guarantee reliability and resistance to high pressures. We fulfill orders on the same day. If you have trouble identifying the threads, you can send us the cut-off fittings - we will make a hose with the exact same fittings.